GNU make manual 翻译( 一百四十五)

   You may notice that the `export' and `unexport' directives work in
`make' in the same way they work in the shell, `sh'.

   If you want all variables to be exported by default, you can use
`export' by itself:

     export

This tells `make' that variables which are not explicitly mentioned in
an `export' or `unexport' directive should be exported.  Any variable
given in an `unexport' directive will still _not_ be exported.  If you
use `export' by itself to export variables by default, variables whose
names contain characters other than alphanumerics and underscores will
not be exported unless specifically mentioned in an `export' directive.

   The behavior elicited by an `export' directive by itself was the
default in older versions of GNU `make'.  If your makefiles depend on
this behavior and you want to be compatible with old versions of
`make', you can write a rule for the special target
`.EXPORT_ALL_VARIABLES' instead of using the `export' directive.  This
will be ignored by old `make's, while the `export' directive will cause
a syntax error.  

   Likewise, you can use `unexport' by itself to tell `make' _not_ to
export variables by default.  Since this is the default behavior, you
would only need to do this if `export' had been used by itself earlier
(in an included makefile, perhaps).  You *cannot* use `export' and
`unexport' by themselves to have variables exported for some recipes
and not for others.  The last `export' or `unexport' directive that
appears by itself determines the behavior for the entire run of `make'.

   As a special feature, the variable `MAKELEVEL' is changed when it is
passed down from level to level.  This variable's value is a string
which is the depth of the level as a decimal number.  The value is `0'
for the top-level `make'; `1' for a sub-`make', `2' for a
sub-sub-`make', and so on.  The incrementation happens when `make' sets
up the environment for a recipe.

   The main use of `MAKELEVEL' is to test it in a conditional directive
(*note Conditional Parts of Makefiles: Conditionals.); this way you can
write a makefile that behaves one way if run recursively and another
way if run directly by you.

   You can use the variable `MAKEFILES' to cause all sub-`make'
commands to use additional makefiles.  The value of `MAKEFILES' is a
whitespace-separated list of file names.  This variable, if defined in
the outer-level makefile, is passed down through the environment; then
it serves as a list of extra makefiles for the sub-`make' to read
before the usual or specified ones.  *Note The Variable `MAKEFILES':
MAKEFILES Variable.